Monitor Streaming Connection (Hybrid Version); Rs232 Com Port Connections - Bosch Divar 700 Series Installation And Operation Manual

28 en | Hardware setup
4.7

Monitor streaming connection (hybrid version)

To connect a monitor in a remote streaming configuration, connect the CVBS monitor output
to a video input. Then connect the monitor to the corresponding loop-through connector.
Figure 4.11 Typical monitor streaming connection (hybrid version)
4.8

RS232 COM port connections

The RS232 COM ports are used to connect a PC to the unit for service purposes. Use a null-
modem cable to connect the serial port of the PC to the unit. The Baud rate can be selected in
the menu system.
Specifications
Connector type: 9-pole D-type male connector
Maximum input voltage: ±25V
Communicaton protocol: Output signals according EIA/TIA-232-F
Figure 4.12 RS232 COM port connectors
Signal name
DCD_in
RX
TX
N/C
System ground
N/C
RTS
CTS
N/C
Table 4.1 RS232 console port socket
F.01U.140.955 | v3.0 | 2009.11
KBD in Ethernet
- | + | G
RS
485
MAL
OUT
VGA
N0 | C | NC KBD out USB USB IR ext
Monitor out
AC
1 2 3 4
Video in
1 2 3 4
Video out
COM 1 COM 2
Installation and Operation manual
B B B
Com 1 Com 2
A A A
CVBS Y/C Biphase Alarm I/O
5 6 7 8 9 10
Video in
5 6 7 8 9 10
Video out
A
Pin number
1
2
3
4
5
6
7
8
9
1 3 5 7
L
R
A B 2 4 6 8
Audio out Audio in
11 12 13 14 15 16
Video in
11 12 13 14 15 16
Video out
B
Description
Carrier detection signal (not used)
RS232 receive signal
RS232 transmit signal
No connection
System ground
No connection
RS232 request to send signal
RS232 clear to send signal
No connection
Bosch Security Systems
Divar 700 Series
9 11 13 15
10 12 14 16