Installation And Configuration - Cisco UNIFIED COMMUNICATIONS UC320W Quick Start Manual

Installation and Configuration

2
Connect a network cable from the WAN port of the Cisco UC320W to
1
your Internet Service or Internet access device.
Connect the supplied power cord to the POWER port and to a power
2
outlet. When the device is fully booted, the POWER/SYS light is steady
green.
Connect your computer to a LAN port on the Cisco UC320W. Do not
3
connect any devices to the LAN ports at this point. Your computer
will receive an IP address in the 192. 1 68. 1 0.x range.
N :
OTE
• You may need to adjust your computer's connecting settings to receive
an IP address dynamically.
• For best results, set the screen resolution to 1024x768 or higher.
Start a web browser. In the Address bar, enter the IP address of the
4
Cisco UC320W (default 192.168.10.1).
To log in, enter the username cisco and the password cisco.
5
Both the username and the password are case sensitive.
When prompted, enter a new username and password. Neither cisco
6
nor admin is valid.
Follow the instructions in the configuration utility to connect the
7
equipment and configure the system.
N :
OTE
• If you are installing the Cisco UC320W in a network with another DHCP
server, complete the Network Topology step in the Getting Started
menu.
• For best results, complete the Upgrade Firmware task and accept all
available firmware updates.
Getting to Know the Cisco UC320W
3
1
4 3 2
LINE (FXO)
1 LINE (FXO) Connect phone lines for traditional phone service.
2 PHONE (FXS) Connect an analog device, such as a phone.
3 WAN Connect to your broadband network access device or to an uplink port
on an Ethernet switch that is connected to the Internet.
4 LAN Connect IP phones and other network devices.
Cisco UC320W Quick Start Guide
2 3
4
1
WAN
PHONE
(10/100/1000)
(FXS)
4 5
3 2 1
LINE
LAN (10/100/1000)
OUT
6 7
Power
LINE
IN 12VDC
3