Leveling The Washing Machine - Toshiba AEW-9770S Owner's Manual

When adjusting the legs, supports the top of the machine. Do not support the machine bottom.
1 Adjust the legs so that the machine does not move.
Note: After adjustment, lock the
nuts of the legs by rotating them in
the direction of the arrow. Make
sure so that the bottom of the main
body front does not reach the floor.
If the bottom is in touch with the
floor, then it will be the cause of
shaking and abnormal noise.
2 Check the position of the air bubble in the floor level
indicator.
•
If the bubble is not positioned inside the circle, adjust
the height by rotating the leg caps.
• Be sure to ground your washing machine when installing. When connecting or disconnecting the ground wire, be sure to
first remove the power plug from the AC socket.
• In case of the machine with two conductor cord connect the ground wire to a proper ground before plugging the power cord
into the socket.
• In case of 3-core cord the ground pin in the plug should be connected to the proper point of the socket.
Do not connect the ground wire in any of the following places under any circumstances:
• Do not connect the ground to gas piping. There is a danger of fire or explosion.
•
Do not connect the ground to telephone lines or lightning rods. There are dangerous during thunder or lightning storms.
Also, as underground water pipes are often made of plastic, don't place grounding rods near them.
Two-core flexible cord
When using the ground terminal
on an AC outlet:
Ensure that the ground wire is securely connected to the ground terminal.
When there is no ground terminal:
•
An optionally available grounding rods is re-commended for use.
The grounding rod should be planted in the dampest ground possible.
INSTALLATION

Leveling the washing machine

3
Unlock Lock
Up
Down
Height adjusting leg
4
Tighten nuts of
adjustable legs
and lock them.
Note: Check the floor level
indicator directly from above.
Standard point
Bubble
Installing the ground wire
Installing the ground wire
17
Depending on locations of the bubble in the horizon-
tal level indicator, place caps and lock legs (Make sure
to fix adjustable legs.)
• Mount the leg caps on
the right-hand legs.
Rotate the height adjust
legs to perform height
adjustment.
Hold down the diagonal line of the washing machine
and make sure that no ratting occurs.
•
Despite the fact that the bubble is inside the circle, the
ratting exists.
Then shaking motion
becomes larger or
some abnormal noise
comes out. Make sure
to readjust in
case the washing
machine rattles.
(Ex) The washing machine is
tilted towards the right.