Install The Rack Kit And Server Into The Cabinet - HP 9000 System Installation Manual

1. Install the Rack Kit and Server Into the
Cabinet
If your R Class server has been factory integrated into a cabinet, or if you are going
to operate the R Class server as a stand-alone unit, proceed to "2. Install Internal
Add-on Options" on page 2-9. Otherwise, follow these instructions to install the
rack kit onto your cabinet and mount the server onto the rack in the cabinet.
WARNING The HP 9000 R Class Enterprise Server weighs about 38 kg (82 lbs). You must
use two people to lift the R Class server into the cabinet. R Class servers are
provided with a handle, located behind the removeable front bezel, to assist
with lifting.
Electrostatic
If you are installing additional cards or peripherals, you must ensure that they are
Discharge
not damaged due to electrostatic discharge (ESD). To prevent such damage from
Precautions
occurring, observe the following ESD precautions when handling and installing
boards:
1. Use a grounding mat and an anti-static wrist strap. These items are included in
2. Wear the anti-static wrist strap to ensure that any accumulated electrostatic
3. Keep uninstalled printed-circuit boards in their protective anti-static bags until
4. Handle printed-circuit boards by their edges after you have removed them from

1. Install the Rack Kit and Server Into the Cabinet

the ESD Field Service Kit (HP P/N A3024-80004).
charge is discharged from your body to ground.
you are ready to install them.
their protective anti-static bags.
R Class System Installation
2- 3