HP 210/210LX User Manual page 53

Placement on the page is wrong or the edges are cut off Placement on the page is wrong or the edges are cut off
Placement on the page is wrong or the edges are cut off Placement on the page is wrong or the edges are cut off Placement on the page is wrong or the edges are cut off
Possible Causes
Auto Fit doesn't enlarge to full size.
Edges of the copy get cut off.
The copy image seems to have shifted or jumped.
Either the document cover was lifted or uneven
pressure was applied to the document cover during
copying.
When using A4-sized paper, the last few lines on
original do not appear on the copy. The paper size
settings are not correct.
6-6 6-6 Troubleshooting and Maintenance 6-6
6-6 6-6
Solutions
Note: Auto Fit will make the copy as big as possible, without
distorting it.
Make sure the copy paper size is correct.
Clean the glass and document cover. Any dirt or smudges on either
the glass or cover will be sensed by the scanner and cause the
enlargement to be inaccurate.
Check to make sure the copy paper size is correct.
Make sure the original is placed in the corner along the two
green borders.
Press the Reduce/Enlarge button repeatedly until Entire 93%
appears on the display. You can also press the Plus (+) or Minus (-)
buttons to scroll through the available Reduce/Enlarge options. Press
the appropriate Start Copy button to make the copies.
Auto Fit will automatically reduce the copy to completely fit on the
page. Press the Reduce/Enlarge button until Auto Fit appears. Press
Start Copy.
Copy again and be sure not to lift or press down on the document
cover.
Set the paper-width selector on the paper tray toward the front
of the tray (for A4-sized paper). Refer to Chapter 1 for these
instructions.