Advertisement
Connecting infrared control cable
The infrared control cable is for when you are using a television
connected to a set-top box, such as a cable vision box. The cable
should be installed covering the infrared receiver of the set-top box.
1.
Connect the infrared control cable to either of the jacks on the
rear side of the optical remote control receiver.
Figure 7. Connecting the infrared control cable
2.
Peel the adhesive sticker from the back of the light emitter end
of the IR Blaster (infrared control) cable (Figure 8.) Position
the light emitter so that it covers the infrared receiver of the
set-top box as in Figure 9. (You can identify the receiver
because it flashes red when you press the set-top box remote
control.) Press the light emitter into place so that the adhesive
sticks it to the infrared receiver as in Figure 10.
Figure 8. Peeling sticker from emitter
7
Advertisement
