Table of Contents
Advertisement
Installing the Adapter
To install the HBAs:
1. Check the motherboard and make any necessary configuration changes to
2. Power down the peripherals, then turn off the computer.
3. Remove the computer cover and save the screws.
4. Choose any PCI bus slot that supports bus mastering.
5. Most motherboards automatically assign an IRQ level and interrupt line; if
6. Remove the slot cover for the slot in which you will install the HBA.
7. Place the HBA in the slot. Carefully press the board into the slot until it seats
8. Secure the HBA to the chassis. Follow the PC manufacturer's instructions.
9. Connect the appropriate cable from the devices to the corresponding
10. Carefully reinstall the computer cover. Insert and tighten the computer cover
11. Power up all external FC devices, then power up the PC and observe the
12. Enable the BIOS only if the boot device is attached to the HBA.
FCA2214/FCA2214DC PCI-X Host Bus Adapters for Linux, NetWare, and Windows Installation
Guide
accommodate the HBA.
your motherboard does not, you must assign the IRQ level and use interrupt
line A for this slot.
firmly.
LC-connector.
screws.
monitor.
The BIOS is disabled by default.
This allows the system to boot faster. For further information about enabling
the HBA BIOS, refer to "Fast!UTIL" on page 43. Consequently, the devices
attached to the HBA are not identified. For example:
PCI Fibre Channel ROM BIOS Version x.xx
Press <Alt-Q> for Fast!UTIL
BIOS for Adapter 0 is disabled
ROM BIOS not installed
Installing the Adapter
21
Advertisement
Table of Contents
