Kenwood CMOS-320 Instruction Manual page 7

Connections
Basic Connections
Navigation system/video monitor (separately available)
Connect the camera to the camera connection cord.
Camera
Switch unit (CMOS-320 only): 1 m (3.28 feet)
Engine key
Main fuse
Battery
CAUTION
• I f the engine key of your vehicle does not have the ACC position, branch the wire energized when the engine key is ON and
connect it to the accessory power cord.
• B efore proceeding to connections, make sure that the engine key is not inserted and disconnect the (-) terminal of the battery
to prevent the short-circuiting incident.
Connect to the rearview camera video input or to the external
video input of the video monitor.
Video cord
Camera's cord length: 1.5 m (4.92 feet),
Power cord: 7.5 m (24.6 feet)
CAM+ (Green/red)
CAM- (Green/white)
Fuse
Accessory power (ACC)
GND cord (Black)
Connect to a metallic part of vehicle (a part of chassis connected to the
negative side of power supply).
GND
Accessory cord (Red)
Connect to the ON-OFF switchable power supply.
Do not connect to a permanently ON power supply.
Power cord
Fuse (2A)
7
|
CMOS-320/CMOS-220