Motorola DCT6200 Setup Manual page 5

THE DCT6200/DCT6208 BACK PANEL
The rear panel of the consists of three types of interfaces — audio, video and data. The table following this drawing describes
cable box
each connection and its use.
1 2
KEY DESCRIPTION
1 TO TV/VCR This coaxial output connector is used to connect the cable box to a TV or VCR operating on channel 3 or 4.
2 CABLE IN The CABLE IN connector receives the incoming signal from your cable service provider.
3 ETHERNET Not currently enabled – intended for future use.
4 AUDIO IN R These connectors are used to connect a set-top between a peripheral audio device such as a CD player and a stereo tuner
AUDIO IN L or A/V receiver. In the current cable box release, the audio from the peripheral device will pass through the cable box when
it is turned off.
5 SPDIF The orange coaxial SPDIF connector is a digital output connection that carries Dolby Digital 5.1 audio or PCM audio.
It is used to connect the cable box to a stereo tuner or A/V receiver to provide surround-sound, theater-style audio.
6 VIDEO IN The VIDEO IN connector accepts a baseband video input from a VCR, camcorder or other video device.
VIDEO OUT The VIDEO OUT connector is used to deliver baseband video to an external device such as a VCR or TV.
7 OUTLET This AC outlet may be used to plug your TV into the cable box as a convenient additional outlet.
8 IR This connector enables the cable box to control a VCR while recording a selected program. Not all electronic program guides support
this feature.
9 USB Not currently enabled – intended for future use.
10 DVI-D Digital Video Interface. To connect high definition monitor or high definition television.
11 AUDIO OUT R The RCA phono-type connectors are used to deliver audio to a stereo receiver.
AUDIO OUT L
12 Y Pb Pr These connectors are used to deliver component video to an HD-ready TV or monitor. Though capable of delivering
standard definition video to your TV or monitor, these cables are necessary to deliver High Definition video.
13 TV PASS CARD For Future Use.
14 S-VIDEO This connector is used to deliver high quality, standard definition video to external devices that accept S-Video inputs,
such as a high-end VCR or TV.
15 OPTICAL The OPTICAL SPDIF connector is an optical digital output connection that carries Dolby Digital 5.1 audio or PCM audio. It is used to connect the
SPDIF cable box to a stereo tuner or A/V receiver to provide surround-sound, theater style audio.
16 IEEE 1394 Firewire Digital Interface to connect high definition monitor or high definition television.
17 POWER INLET For the female end of the supplied power cord.
3 4 5
8 9 10 11
6
12 13 14 15 16
(Not currently enabled.)
7
17