Powering On The Handset; Attaching The Belt Clip - Toshiba IP4100 SIP DECT User Manual

3) Insert the bottom of the battery first, then lay the battery down and push it gently until it
snaps into place.
4) Replace the cover and slide it up into place.

Connect the charger AC adapter to the
charger's AC jack.

Plug the other end of the adapter into
a standard 240V AC power outlet.

Place the handset in the charger with
the display facing forward. The display
on the handset should light up and the
charger LED should turn on. If it
doesn't, reseat the handset or try
plugging the AC adapter into a
different outlet.

Place the spare battery in the back
section of the charger. (Pull the battery
latch back to insert the battery.

Powering on the Handset

To power on the handset, press End (
the unit with the strongest signal.
To power off the handset, press and hold End for about 4 seconds.

Attaching the Belt Clip

Line up the holes on each side of the handset. Insert the belt clip into the holes on each side of
the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the tabs from the holes.
Charge each battery completely (about 10 hours) before using it.
). The handset searches for a base and connects to