Screen Descriptions; Group 1-Startup Screen And Menu Directory; Group 2-Configuration Screens; Group 3-Diagnostic Screens - GE MDS 4790M Installation And Operation Manual

TX [xxxx] command, page
43
This graphic points you
to the corresponding PC
command
MDS 05-3628A01, Rev. B

6.5 Screen Descriptions

This section describes each of the front panel display screens. The commands
are cross-referenced to descriptions of corresponding commands entered from
a connected PC using the graphic at left.
These screens are presented in four major groups:
Group 1—Startup Screen and Menu Directory (page 53)
These screens are starting points for all programming and viewing activities.
Group 2—Configuration Screens (page 53)
The Configuration screens are used to view or define the radio's operating
parameters. They include:
• Set/display access level (front panel display mode)
• Set/display transmit and receive frequency
• Set/display output power
• Set/display modem speed
• Set/display data port baud rate and parity
• Enable/disable pre-emphasis and de-emphasis
• Set/display Clear to Send (CTS) delay
• Set/display Push to Talk (PTT) delay
• Set/display soft carrier dekey delay
• Enable/disable Transmit Timeout Timer
• Set/display Transmit Timeout Timer delay
• Enable/disable RX Timeout Timer
• Enable/disable repeater mode
• Enable/disable RX Mute mode
• Enable/disable continuous keying
• Key/dekey radio manually
• Display unit address
• Set/display keying mode (key on data/key on RTS)
• Enable/disable data buffering
• DLINK on/off setting
• DLINK baud rate setting (set/display)
• Set/display DTYPE (Diagnostic radio type)
• Set/display transmit and receive audio level
• Enable/disable transmit gain and receive pad
• Display major and minor alarm masks and alarm sense
• Set/display front panel display contrast and intensity
• Set/display owner name and message
• Set/display time and date
Group 3—Diagnostic Screens (page 61)
The Diagnostic screens display important status information for the local and
remote radio, as well as run several tests useful in locating system problems.
The Diagnostic screens include:
• Display operating status information
• Display active radio status
MDS 4790M (MPT 1411) I/O Guide 49