Installing The Amplifier System; Falling Prevention - Sharp HT-SL72 Operation Manual

Installing the Sound Bar (continued)
4
Screw the wall mount angle to the wall as shown in
the illustration. (Total screw is 4 pieces)
●
Make sure that the screw and the wall can support
a load of 45 lbs (20 kg).
Wall mount angle
(screws x 2)
Wall surface
(screws x 2)
5
Align the wall mount slot at the Sound Bar to the
wall mount angle.
6
Slot the Sound Bar into the wall mount angle.
7
Fix them securely.
Wall surface
Note:
Make sure all screws are fully tightened. (screws are not
supplied)

Falling prevention

Safety wires (not supplied) are useful to prevent the Sound
Bar from falling off the table.
Loop the safety wires (not supplied) into each hole as
shown and tie the safety wires to the LCD TV stand.

Installing the Amplifier System

The Amplifier can be installed as below:
1
Wall
Horizontal
mount
To mount the Amplifier on the wall, perform the following
angle
steps.
1
Make a hole on the wall using a drill.
3/8" (8 - 9 mm)
2
Fix a wall mount plug into the hole using a
hammer, until it is flush with the wall surface.
3
Fix screws into the wall for the Amplifier, as
shown in the illustration.
●
Make sure that the screw and the wall can support
a load of 45 lbs (20 kg).
●
Fix the screws, so the screw head extends about
7/32" (5.5 mm) from the wall.
Wall surface
4
Fix the screws. Hook the Amplifier on the screw
heads and make sure it is properly secured.
E-9
2 3
Vertical
1-1/4" (32 mm)
Wall mounting Wall surface
screw
Wall surface
On the wall
7/32"
(5.5 mm)