Settings For Call Diverting - Nokia N-Gage Extended User Manual

Options during a call
Options that you can use
during a call are network
services. Press Options
during a call for some of the
following options:
Mute or Unmute, End active
call, End all calls, Hold or
Unhold, New call, Conference,
Private, Drop participant,
Answer, and Reject.
Swap is used to switch
between the active call and the call on hold.
Transfer is used to connect an incoming call or a call on
hold with an active call and to disconnect yourself from
both calls.
Send DTMF is used to send DTMF tone strings, for example,
passwords or bank account numbers.
Glossary: DTMF tones are the tones you hear when
you press the number keys on the game deck keypad.
DTMF tones allow you to communicate with voice
mailboxes and computerised telephony systems, for
example:
1 Key in the digits with
generates a DTMF tone, which is transmitted while the
call is active. Press repeatedly to produce: *, p
(inserts a pause of approx. two seconds before, or
20
between DTMF characters.), and w (if you use this
character, the remaining sequence is not sent until you
press Send
produce #.
2 To send the tone, press OK.
Tip! You can also store a sequence of DTMF tones
for a contact card. When you make a call to the contact,
you can retrieve the sequence. Add DTMF tones to the
phone number or

Settings for call diverting

Go to Menu→ Tools→
When this network service is activated, you can direct your
incoming calls to another number, for example, to your
voice mailbox number. For details, contact your service
provider.
• Select one of the divert options, for example, select
busy to divert voice calls when your number is busy or
when you reject incoming calls.
• Select Options→
Cancel
check whether the divert is activated or not.
• To cancel all active diverts, select Options→
diverts.
- . Each keystroke For information about the divert indicators, see 'Indicators
related to actions', p. 9.
again during the call). Press to
DTMF fields in a contact card.
Call divert.
Activate to set the divert setting on,
to set the divert setting off, or Check status
Cancel all
If
to