Hitachi SV 12SG Handling Instructions Manual
Orbital sander
Hide thumbs
Also See for SV 12SG:
- Handling instructions manual (112 pages) ,
- Instruction manual (52 pages) ,
- Safety instructions and instruction manual (48 pages)
Table of Contents
Advertisement
Quick Links
Orbital Sander
Model SV 12SG
Handling instructions
Note:
Before using this Electric Power Tool, carefully read through these
HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is
recommended that these INSTRUCTIONS be kept readily available
as an important reference when using this power tool.
Advertisement
Table of Contents
Related Manuals for Hitachi SV 12SG
Summary of Contents for Hitachi SV 12SG
-
Page 1: Handling Instructions
Orbital Sander Model SV 12SG Handling instructions Note: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool. -
Page 2: General Safety Rules
c) Avoid accidental starting. Ensure the switch is in GENERAL SAFETY RULES the off position before plugging in. Carrying power tools with your finger on the WARNING! switch or plugging in power tools that have the Read all instructions switch on invites accidents. Failure to follow all instructions listed below may result in d) Remove any adjusting key or wrench before electric shock, fire and/or serious injury. -
Page 3: Specifications
PRECAUTION Keep children and infirm persons away. When not in use, tools should be stored out of reach of children and infirm persons. SPECIFICATIONS Voltage (by areas)* (110 V, 120 V, 220 V, 230 V, 240 V) Power Input 200 W* No-load speed 14000/min 110 mm ×... -
Page 4: Practical Operating Procedures
CAUTION Never turn the power switch ON when the sander is contacting the surface to be sanded. This is necessary Sanding paper to preclude damage to the material. The same applies when switching the power OFF. 2. How to hold the orbital sander While gripping the housing, lightly press the sander against the surface to be sanded so that the sanding paper uniformly contacts the surface, as shown in... -
Page 5: Maintenance And Inspection
C: No. Used D: Remarks CAUTION Repair, modification and inspection of Hitachi Power Tools must be carried out by an Hitachi Authorized Service Center. This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service Center when requesting repair or other maintenance. - Page 8 Hitachi Koki Co., Ltd. Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99129511 G Printed in China...