GE AvantaPure Operation Manual page 27

Avantapure professional series water treatment system
Table of Contents

Advertisement

8.
Press and hold the SET and UP button for 5 seconds
to cancel regeneration, and cycle the control back to
the service position.
9.
Start another regeneration. Advance the controller to
the brine refill position (C8) to prime the line between
the regenerant tank and the valve (conditioner only).
A. Slowly open the main water supply valve
again to the fully open position. Be sure not to
open too rapidly, as that would push the
media out of the media tank.
Note: As you advance through each cycle, there will be a
slight delay before you can advance to the next cycle.
There will be a pause after the brine draw and slow rinse
cycles (system pause). This cycle allows the water/air
pressure to equalize on each side of the valve discs.
B. With the water supply completely open, when
you arrive at the brine tank refill cycle, the
controller will direct water down through the
line and into the tank. Watch the bottom of
the tank until all air bubbles have been
purged from the line and the water level is
rising.
C. Let the water flow down the line to the tank
only until the rising water is vis able.
D. Simultaneously press and release the SET and
UP buttons to advance to the Brine Make-up
cycle. After the Brine Make-up cycle is
reached, press the SET and UP buttons to
advance to the Brine Draw/Slow Rinse cycle.
10. Draw water from the regenerant tank.
A. With the controller in this position, check to
see that the water in the regenerant tank is
being drawn out of the tank. The water level in
the tank should recede very slowly.
B. If the water in the regenerant tank does not
recede, or goes up, refer to the
Troubleshooting section.
11. If the water level is receding from the regenerant
tank, wait for the tank check valve to stop the water
flow. Press the SET and UP buttons to advance the
controller back to the treated water position.
12. Finally, turn on a faucet plumbed after the water
conditioner. Run the faucet until the water runs clear.
The Water Conditioning System is Now
Fully Operational.
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avantapure professional 269

Table of Contents