Maintenance; Maintenance Schedule - Husqvarna DT18BF Operator's Manual

Power rake seeder
Hide thumbs Also See for DT18BF:
Table of Contents

Advertisement

Maintenance Schedule

The following is a list of maintenance procedures that must be performed on the machine. For those points not
described in this manual, visit an authorized service workshop.

MAINTENANCE

Check the engine oil level
Replace engine oil
1)
Check the air filter
Replace air filter cartridge
Clean sludge reservoir for fuel system
Check and clean the spark plug
Replace spark plug
Check idle speed
Check and adjust play in valves
Clean fuel tank
3)
Check, replace fuel lines as necessary
Check clutch and clutch cable
Check flail blade lock washers
Check decals and warning signs
Check the seed holes for the seeder
Check wear and tension on the belts
Check blade wear and condition
Check the chassis, bolts and set screws
Check the seed control lever for the seeder
Check the wire mountings on the seeder
Lubrication; see the Lubrication schedule
First change after 20 hours.
1)
Performed every second year.
4)
With daily use, the machine shall be lubricated twice weekly.
No service operations may be performed on the engine or unit unless:
The engine is stopped.
The ignition cable has been removed from the spark plug.
The machine is securely parked where it will not tip or begin rolling.
20
MAINTENANCE
2)
3)
3, 4)
In dusty conditions maintenance is required at shorter intervals.
2)
WARNING!
Daily
Maintenance interval - months/hours
Before
Staring
1/25
3/50
Performed by authorized service workshop.
3)
6/100
12/300

Advertisement

Table of Contents
loading

Table of Contents