Husqvarna Rider Pro 18 Operator's Manual page 64

10. Parking brake wire
Remove the transmission cover; see "Gear lever".
Unhook spring (A) from screw (B) if necessary.
Push the rubber protector aside to lubricate the
wire.
Lubricate the wire using an oil can, press the brake
pedal a few times and lubricate again.
Refit spring (A) and the transmission cover.
11. Transmission oil level
1. Check the level of the transmission oil by looking
through the air intake mesh. The oil level should
be between the "MIN" and "MAX" marks on the
oil reservoir at 20°C.
If it is necessary to top up the oil you must
remove the transmission cover first.
2. Unscrew the cap from the oil reservoir and top
up with SAE 10W/30 grade engine oil, class SF–
CC, until the oil level reaches the "MAX" mark.
Screw the cap back onto the oil reservoir and
refit the transmission cover.
12. Transmission
The oil should be changed by an authorised service
workshop, and is described in the Workshop
Manual.
Filter replacement on Pro 18 is done at the same
time as changing the oil.
LUBRICATION
A
B
63
English –