1.4
Position Adjustment of Carriage 1 and 2
(1) While pushing carriage 2 to exit side, tighten
the screw on the front.
(2) Fasten carriage 1 to the wire: Each screw on
the front and rear should be tightened tem-
porarily.
(3) While pushing carriage 1 to the exit side (car-
riage 2), tighten the screws
..... on the front and rear.
Note: Move carriages 1 and 2 to the exit side by
rotating the shaft and check to make sure
that the claws of both carriages (two for each)
touch the inside surface of the frame at the
same time.
Oct. 1995 © TOSHIBA CORP.
[Exit side]
1 - 17
[Exit side]
Carriage 2
Carriage 1
1550 ADJUSTMENT