Table of Contents
Advertisement
LTC 0440 | Installation Manual
CAUTION
•
To avoid damaging the CCD sensor when using a C-
mount lens, turn the 'green' back-focus ring counter
clockwise until it stops ('Back focus adjustment')
before mounting the lens.
•
Lenses weighing more than 0.5 kg (1. 1 lbs) must be
separately supported.
Note:
If a short circuit is detected on the lens connector, the on-screen
display (OSD) failure message 'LENS SHORT CIRCUIT' is shown.
The lens circuit is automatically disabled to avoid internal damage.
Remove the lens connector and check the pin connections.
Back focus adjustment
•
Camera accepts both C and CS-
mount lenses.
1. Unlock the back focus locking
button.
2. Turn the back focus adjustment as
required. (See Note 1).
3. Lock the back focus locking button.
Notes:
1. To optimize picture sharpness in
both bright and low-level lighting, it
is recommended to adjust the back focus when carrying out the
set-up procedure. The camera's unique 'Lens Wizard' allows
focusing at maximum lens opening to ensure that the object of
interest always remains in focus.
Bosch Security Systems | 2004-11
EN | 7
Advertisement
Table of Contents
