Calibration Instructions - Husqvarna 70 PP Owner's Manual

CALIBRATION INSTRUCTIONS

CALIBRATION INSTRUCTIONS
CALIBRATION INSTRUCTIONS CALIBRATION INSTRUCTIONS
The spreader was factory calibrated, however, calibration should be checked occasionally to
assure optimum performance.
1.
Pull the on/off lever to the "OFF" position.
Set the rate control plate to setting "B".
Pointer Screw
Pointer
MODEL
70 PP
Rate Control Knob
2.
Flip on/off control lever to the "ON" position.
Check the port opening. It should be just open.
If adjustment is necessary, continue to step #3.
Rate Control Plate
NOTES NOTES
NOTES NOTES
3.
Loosen the rate control knob and slide the rate
plate until the port is just opening. Loosen
pointer screw and move pointer until it aligns
with "B" on the rate plate. Retighten pointer
screw.
7
VIEW IS
INSIDE OF
HOPPER
Port is just open