Maintenance; Gear Housing; Cleaning And Lubrication; Maintenance Schedule - Husqvarna HA 110 Operator's Manual

Gear housing

There are three grease nipples on the gear housing. Use a
grease gun to top up with grease. This should be carried out
approximately every 20 working hours. Use Husqvarna
special grease, part no. 503 98 96-01.
CAUTION! The gear housing must not be filled completely
with grease. The grease expands as the machine heats up
during operation. If the gear housing was completely filled
with grease it could damage the seals and lead to leakage of
grease.
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.

Cleaning and lubrication

After you have used the machine clean any resin and plant
residue from the blades using cleaning agent 531 00 60-75
(UL22).
Always lubricate the blade bars with special grease, part no.
531 00 60-74 (UL 21) before use.

MAINTENANCE

Maintenance schedule

Below you will find some general maintenance instructions. If
you need further information please contact your service
workshop.
Daily maintenance
1
1 Check that the blades do not move when the engine is
idling or when the choke is in the start throttle position.
2 Check that the hand guard is not damaged. Replace the
guard if damaged. (HA 110)
Weekly maintenance
1
1 Fill the gear housing with grease. This should be carried
out approximately every 20 working hours.
2 Check that the screws that hold the blades together are
correctly tightened.
Technical data
Technical data
Weight
Weight, Lbs/kg
Blades
Length, mm
Blade speed, cuts/min
2
A
B
2
HA 110
2,0
550
4184
HA 850
2,3
550
4184
– 11
English