Calling - Kenwood TK-260G Instruction Manual

Note:
Your dealer selects one of four methods of operation for [MONI]:
Hold down the button to open the squelch; release the button to
•
close the squelch, or
• Hold down the button to deactivate QT, DQT, or 2-Tone
decoding; release the button to activate decoding, or
Press the button to deactivate QT, DQT, or 2-Tone decoding;
•
press the button again to activate decoding.
• Disabled.
If your transceiver is programmed with QT, DQT, or 2-Tone
Signaling, pressing [MONI] will not affect output from the speaker;
even at full volume there will be virtually no noise audible from the
speaker.
Receiving a signal with the same 2-Tone signaling as is
programmed in your transceiver will cause the LED indicator to flash
orange. An alert tone is heard if so programmed by your dealer.

CALLING

1 Press [MONI], then listen for a few seconds to make
certain that the channel is not being used.
2 Hold the transceiver about 3 ~ 4 cm (1 1/2 inches) from
your lips, press the [PTT] switch, and speak in your
normal speaking voice.
• The LED lights red while you are transmitting.
3 Release the [PTT] switch to return to the receive mode.
12