Table of Contents
Advertisement
ACUIX IP Rugged Housing and Dome
Installation Overview
10
Rugged Housing and Dome Model Numbers
For other model numbers and information on the Honeywell Video web site, see
Documents
on page 11.
Housing
•
HDH00RD00: Rugged, white, digital
Lower Dome
•
HDB00R0CW: Rugged, clear lower dome, white trim ring
•
HDB00R0SW: Rugged, smoked lower dome, white trim ring
For all outdoor installations, joints, bolts, and screws in the mount must be properly
sealed to prevent moisture from entering the housing.
A complete ACUIX IP system installation is a multi-step process and depends on
individual hardware configurations. Some of the information to complete the installation
may be in the manual associated with the hardware being installed. For related
documentation and the link to the Honeywell Video web site, see
page 11.
A typical installation has the following steps. The order may be slightly different for each
type of installation.
1.
Connect the field and terminal block wiring on the housing interface board,
Also refer to the
ACUIX IP High Speed Dome User Guide
2.
Set the DIP switches on the scan assembly circuit board,
ACUIX IP High Speed Dome User Guide
3.
Mount the bracket to the ceiling, wall or other surface,
4.
Mount the housing,
page
5.
Install the scan assembly into the premounted housing,
6.
Install the lower dome to cover the scan assembly and enclose the housing,
page
22.
7.
Refer to the
ACUIX IP High Speed Dome User Guide
•
Install the Honeywell IP Utility and ACUIX Web-Client software, configure the
network and discover devices.
•
If applicable, continue setting up and configuring other custom settings
including privacy zones and preset tours.
•
If required or applicable, proceed to user configurations based on other
hardware, for example, a DVR.
for more information.
20.
Related
Related Documents
page
for more information.
page
17. Also refer to the
page
19.
page
21.
to complete these steps:
on
13.
Advertisement
Table of Contents
