Troubleshooting - Bosch Sensixx x DA50 Operating Instructions Manual

Trouble shooting
Problem Probable cause
The iron does not 1. Temperature control set to minimum.
heat up. 2. No mains supply.
3. The "secure" system has been
"Auto off" indicator • The "secure" system has been
lamp flashes.
The clothes tend to • The temperature is too high.
stick.
Water drips out of 1. Temperature control setting is too
the soleplate
together with steam.
2. Steam control is set too high in
3. You have pressed the shot of steam
4. Pure distilled water has been used
Steam does not
1. Steam control is set to "
come out.
2. No water in the tank.
3. The temperature is too low.
Spray does not 1. No water in the tank.
work. 2. Obstructed mechanism.
Smoke comes out • This may be caused by the
when connecting the
iron for the first time.
Deposits come out • Traces of lime scale are coming out
through the holes in
the soleplate
If none of the above solves the problem, get in touch with an authorised technical service.
You can download this manual from the local homepages of Bosch.
activated. The iron is set to
stand-by.
activated. The iron is set to stand-by.
low.
conjunction with a low temperature.
button repeatedly without waiting for
5 seconds between each press.
(see "Filling the water tankk"
section) or other products such as
fragrant water have been added to
the tank.
position.
Anti-drip system is activated.
lubrication of some of the internal
parts.
of the steam chamber.
Solution
1. Turn to a higher position.
2. Check with another appliance or
plug the iron into a different socket.
3. To reconnect the iron, just move it
about gently.
• To reconnect the iron, just move it
about gently.
• Turn the temperature control down and
wait until the iron has cooled down.
1. Turn the temperature control to a
higher setting (between "••" and "max")
and wait until the lamp goes out.
2. Set the steam control to a lower
setting.
3. Wait 5 seconds between each press
of the jet of steam button.
4. Mix distilled water with tap water as
directed in the "Filling the water tank"
section and never add any other
products to the water tank (unless
recommended by Bosch).
1. Set the steam control to an open
"
steam position.
2. Fill the tank.
3. Set to a higher temperature if
compatible with the fabric.
1. Fill the water tank.
2. Contact the Technical Service.
• This is normal and will stop after a
few minutes.
• Carry out a cleaning cycle (see
"Calc'n clean" section).
17
B O SCH