Handheld Microphone; Belt-Pack Transmitter - Bosch MW1-RX Installation And User Instructions Manual

UHF Wireless Microphone System | Installation and User Instructions |
5.2

Handheld microphone

1 Turn the handheld microphone ON by switching the
ON/OFF switch on the rear of the microphone to
the ON position.
2 Slide the cover down by pushing the rimmed knob
on the side.
Frequency selection
1 Press the wheel for 3 seconds to activate the menu.
2 Once you see "MHZ" blinking, you can select the
required frequency by rotating the wheel UP and
DOWN.
3 Press the wheel to store the selected frequency.
Note
In case the handheld microphone is locked,
the settings can not be changed. For unlock,
see instructions on Lock mode.
Sensitivity adjusting
1 Press the wheel for three seconds to activate the
menu.
2 Press the wheel 1 time and Sensitivity (SEnSit)
appears on the display.
3 Rotate the wheel UP and DOWN to adjust the
setting.
4 Press the wheel to store the setting.
Sensitivity range: 0, -10, -20, -30 dB.
Default setting of sensitivity is -20 dB.
Lock mode
1 Hold the wheel for 3 seconds to activate the menu
2 Press 2 times to select the "Lock mode".
3 Push the wheel UP or DOWN to change the setting.
4 Press the wheel to store the setting
Note
In case the LOCK mode is ON, the handheld
microphone cannot be switched OFF.
Bosch Security Systems | 2006-01 | 9922 141 50701ml
5.3

Belt-pack transmitter

Frequency adjusting
1 Turn the belt-pack ON by setting the switch to the
ON position.
2 Slide down the slider around the belt-pack
transmitter.
3 Push the SET button for 3 seconds to activate the
Menu.
4 Once "MHZ" is blinking, the required frequency can
be selected by using the UP and DOWN buttons.
5 Press the SET button again to store the selected
frequency.
Note
In case the belt-pack is locked, the settings can
not be changed. For unlock, see instructions on
Lock mode
UP
Down
figure 5.3: Adjusting the frequency
en | 16
"MHZ"
SET