Replacement Of Supply Cable - Whirlpool ACG 900 IX User Manual

IMPORTANT
Do not use excessive water when cleaning the oven and avoid
water passing through the fan grill or ducts in the oven back .
Avoid letting grease deposit collect around the upper heating
element: it will cause smoking and may start a fire.
Fig. 6
OVEN DOOR REMOVAL AND REFITTING
Open the oven door in half-open position (at the first hinge release)
and using both hands, remove the glass panel (see fig. 7A).
Open the oven door completely and turn the two hinge disks "A"
clockwise (fig.8). Reclose to about 45° and pull gently (fig. 9).
To reassemble, keep the door at 45° and insert the arms of the
hinge in the slots on the front of the oven. Reposition it correctly
following the above steps in the reverse order
Fig. 7A
A
Fig. 8
SERVICE INSTRUCTIONS
All service should be carried out be a authorised service
technician only.
REPLACEMENT OF THE SUPPLY CABLE
ALWAYS UNPLUG THE PLUG FROM THE CURRENT SOCKET
OR SWITCH OFF THE CURRENT ON THE POWER SUPPLY
LINE BY MEANS OF THE MAINS CIRCUIT SWITCH, BEFORE
CARRYING OUT ANY MAINTENANCE ON THE OVEN.
In case the cable is damaged, replace it in accordance with the
following instructions:
- switch the appliance off at the control switch
- open the box of the supply board as described on the picture
below; - unscrew the clamp «A» fixing the cable;
Fig. 7
- replace the cable with one of the same length and in accordance
with the specification described on the table;
- the "green-yellow" earth wire must be connected to the terminal
" " and it must be about 10 mm longer than the live and
neutral wires;
- the «blue» neutral wire must be connected to the terminal
marked with letter «N.» - the live wire must be connected to the
terminal marked with letter «L».
TYPE AND SECTION OF SUPPLY CABLE
230V-240V~
H05RR-F
H05VV- F
A
WARNINGS
Before performing any repair or operation, switch the
appliance off and close the gas tap.
The manufacturer declines all responsibility for any damage to
Fig. 9
persons, animals or things caused by failure to observe the rules
indicated above. In case it is necessary to repair or replace the
inside components, act as follows:
WARNINGS
Isolate the cooker from the electricity supply before attempting
to replace the oven lamp.
The oven lamp used is of a special type withstanding high
temperatures. To replace it, act as follows: disassemble the
protecting glass (A) and replace the burnt lamp with one of the
same type. Reassemble the protecting glass.
10
1
L
2
3
4
N
5
A
Ø 3 x 1.5 mm
Fig. 10
2