Overview - Mitsubishi Electric EY-3DGS-80U User Manual

Overview

With the 3D glasses and 3D emitter, you can enjoy 3D images when you watch
the 3D supporting programs on the projectors supporting 3D images.
You can wear the 3D glasses over vision corrective glasses.
Make sure to read the "Safety precautions" on pages 2 to 3 before using
the 3D glasses.
Battery case
Install the supplied coin type
lithium battery (CR2032).
If necessary, remove
the nose pad.
(inside the 3D
Glasses)
Lens
(liquid crystal
shutter)
Power switch (ON/OFF) and indicator
When turning on the power:
Turn ON the power switch.
The indicator lights up.
When turning off the power:
Turn OFF the power switch.
The indicator goes off.
* When the infra-red signal from the 3D emitter is interrupted, the power turns
off automatically after about 5 minutes, and the indicator goes off.
To turn on the power again, set the power switch to OFF and then ON.
* If the battery is running low, the indicator goes off immediately when you
turn on the power.
Infra-red receiver (3 places)
Receives infra-red signals from the
3D emitter.
The liquid crystal shutter open/close
timing is controlled by receiving
infra-red signals from the 3D emitter,
which provide the 3D expression of
the images.
Power switch
Indicator
EN-7