Leak Test Procedure (Universal Lpg); Conversion To Natural Gas - Electrolux EQBM100AS User Manual

Leak test procedure (Universal LPG)

• Ensure all gas valves are in the 'OFF' position.
• In a small container, mix a solution of water and
detergent or soap.
• After connection of the hose, turn on the valve at the
gas bottle or mains as appropriate.
• Using a brush apply the solution to the gas connection
points and look for bubbles forming.
• Bubbling will indicate a leak.
• Turn off the valve and re-tighten the joint. Repeat the
leak test.
• If the leak persists, turn off the gas at the isolation
valves and contact a licensed gas fitter to correct.
electrolux en:v barbecue leak test procedure/conversion to natural gas 7

Conversion to Natural Gas

Preparing the unit for Natural Gas installation.
This barbecue is supplied set up for Universal LPG and is
labelled accordingly. A Natural Gas conversion kit can be
purchased from Electrolux Spare Parts to enable conversion
to Natural Gas use.
NOTE: Conversion of this unit to Natural Gas must be
carried out by a qualified licensed person and a Certificate of
Compliance must be issued to the owner on completion of
the installation and conversion.
The conversion kit consists of:
•
•
•
•
leak test points
Procedure
1. Changing the injectors
check hose for
signs of abrasions,
cracks or leaks
Regulator
Hose with quick connect bayonet fitting one end
Small plastic bag containing 4 brass injectors
Natural Gas sticker
• Remove warmer drawer as shown on page 5.
• Remove front service panel by loosening the screws in
3 places. Screws need only be loosened, and not fully
removed.
• Lift service panel from the bottom and swing out
approximately 45 degrees to release the top edge of
the service panel.
loosen 3 screws
on underside
of service panel
swing out to release
service panel