Intended Use; Assembly And Adjustments - DeWalt D28090 Instruction Manual

• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ............ volts
Hz .......... hertz
min ......... minutes
....... direct current
........... Class I Construction
............... (grounded)
............ Class II Construction
............... (double insulated)
BPM....... beats per minute
sfpm ...... surface feet
.............. per minute (sfpm)
DESCRIPTION
FIG. 1
(FIG. 1)
WARNING: Never
B
modify the power tool or
any part of it. Damage or
personal injury could
result.
A. On/off switch
B. Spindle lock
C. Guard
D. Side handle

INTENDED USE

Your angle grinder
has been designed for
professional grinding and cutting applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
A ............amperes
W ...........watts
..........alternating current
n o ...........no load speed
...........earthing terminal
...........safety alert symbol
.../min ....revolutions or
...............reciprocation
..............per minute
A
D
C
DO NOT use grinding wheels other than center depressed wheels
and flap-disk.
This heavy-duty angle grinder is a professional power tool. DO NOT
let children come into contact with the tool. Supervision is required
when inexperienced operators use this tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories.
WARNING: Prior to assembly and adjustment, ALWAYS unplug
tool.
WARNING: Never use the tool without the guard in place.
Mounting and Removing the Guard
(Fig. 2)
WARNING: Turn off
and unplug the tool
before making any
adjustments or removing
or installing attachments
or accessories. Before
reconnecting the tool,
depress and release the
paddle switch to ensure
that the tool is off.
1. Place the angle grinder
on a table, spindle up.
2. Align the lugs (F) with
the notches (G).
3. Press the guard down
and rotate it to the
required position.
8
FIG. 2
C
F
G
H
G