Setting The Disklavier For The Internet Connection - Yamaha Disklavier E3 Classic Operation Manual

Setting the Disklavier for the Internet Connection

[SETUP] "Network"
You can change various settings related to the Internet connection. In most
cases, you do not have to change the default factory settings.
Information
You can confirm the information of network settings.
Use DHCP
Select the method to determine several addresses. If your router has
DHCP server function, we recommend that you to select "DHCP" or
"DHCP+DNS."
DNS1/DNS2
Enter the address of the primary and secondary DNS server. These
settings must be made when Use DHCP is set to "DHCP+DNS" or
"MANUAL."
IPAddr./SubMask/Gateway
Enter the address of the control unit, subnet mask and gateway server.
These settings must be made when Use DHCP is set to "MANUAL."
Proxy/Proxy Port
Enter the name and the port number for the proxy server. These settings
are necessary only when a proxy server is located in your local network.
1
Press [SETUP] on the remote control.
The setup menu screen appears.
=SETUP MENU=
*TimerPlay
*MIDI
2
Select "Network" with the cursor buttons ([
[ ]), then press [ENTER].
The network setting screen appears.
(1/3)
*AudioI/O
*M-Tune
(2/3)
=SETUP MENU= 
*Network *Playback
*Shortcut
=Network= -+
Information
>Use DHCP =DHCP
Internet Direct Connection (IDC)

To use the Internet connection,
inquire of your Internet service
provider.
Note:
For information about DNS server
address, IP address, subnet mask
and gateway server address, inquire
of your internet service provider.
] [ ] [ ]
Chapter
9
103