To Remove And Replace The Oven Door; Oven Light; Care & Cleaning - Electrolux 30” Gas Range Use & Care Manual

Care & Cleaning
to ReMove and RePlace oven dooR
1. Open the door to the fully opened position.
2. Pull up the lock located on each hinge support toward front of range. You may have to
apply a little upward pressure on the lock to pull it up.
3. Grasp the door by the sides, pull the bottom of the door up and toward you to disen-
gage the hinge supports.
Keep pulling the bottom of the door toward you while rotating the top of the door to-
ward the appliance to completely disengage the hinge levers.
4. Proceed in reverse to re-install the door. Make sure the hinge supports are fully en-
gaged before unlocking the hinge levers.
Lock in normal
position

oven liGHt

An interior oven light will turn automatically when the oven door is opened. The oven
light may be turned on when the door is closed by using the oven light switch located
on the control panel.
The lamp is covered with a glass shield. The glass shield can be remove to be cleaned
manually or to change oven light.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
to replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. To remove the glass shield, pull the back side of the shield toward the inside of the
oven in a manner to lift it up from the oven side.
4. The glass shield should come out easily by pushing a little toward front of the wall
oven.
5. Replace halogen light appliance bulb taking care to not touch the bulb. If you
touch the halogen bulb with finger that can damage it and also burn it.
6. To replace glass shield, proceed in reverse.
Lock engaged
for door removal
31
HINGE SLOT - Door removed
from the appliance
lift backside of glass
shield and remove it.
Halogen
light bulb