Table of Contents
Advertisement
Manual Fine Tuning (MFT)
This adjusuuent is not necessary under normal receiving conditions.
However, in areas of inferior broadcast conditions where adjustment is
necessary for hewer picture. r'ollow• these steps.
1. Select the channel you want to fuetune with the PAT or Position
Number buuuus.
2. Press MENU, and then press < or > to display SET t3P menu.
3. Press n or v to highlight MET (page 2), and then press ( or
until the best possible picture and sound err Obtained.
rm
SKIP I CFF
While pressing the hurron, < at > will Flash.
Note:
t44;en operating the A4FT AFT,s autornattcally set OFF
Automatic Fine Tuning (AFT)
The Al I function aurornarically toners slight flucmarions when
receiving signals.
1. Select the chanucl you want to fine-tune with the PA ♦ or position
Numhrr htirtons.
2. press MENU, and then press < or > to display SIFT UP menu.
3. Pres. ^ or u to highlight AFT (page 2), and then press < or > ro
select ON.
Position
Number
°0
010 o tape
0 0 0
15 J1
to. 17
0
SET UP
O
4K
SKIP
ON
MET u
-0
Note:
WTnf,• • to the A! ! 01-1 - mode, "
",nark
appears to thr. left of III,'! pos,uo,i,t,rmhor
Tu change progr<uu position:
• Enter the desired program position
number using the Channel position
buttons off the remote control.
For program positions below 10, use
(0 and) the regnired number i.e., for
program position 4.
• You c an also change the program position
by using the P A Or PT button.
I'he program position will be displayed on
site screen with tire StercolBilingnal
indicator.
Advertisement
Table of Contents
