Table of Contents
Advertisement
Starting and configuring the TruVision NVR 40
Starting and configuring the TruVision NVR 40
This chapter describes the start up procedure and the necessary software
configuration of the TruVision NVR 40 unit.
Turn on the unit
Turn on the unit (press the power button on the unit). See Figure 7 on page 14.
The VisioWave video operating system (VOS) and the VisioWave Security Service
software will then start up automatically. Configure the network parameters the first
time the video equipment is switched on. See "Network configuration" on page 23.
Otherwise the VisioWave Central Configuration server will not detect the unit and its
input and output video channels on the net.
Installing on a network
The TruVision NVR 40 is installed on an Ethernet network. This involves assigning it an
IP address, either manually or via an automated network service (DHCP). Depending
on your network, select one of the following procedures:
• Automatic configuration using DHCP, see "Network configuration" on page 23.
• Manual configuration using fixed IP address, see "Network configuration"
on page 23.
Note: The TruVision NVR 40 has the default IP address 192.168.1.2 (Mask 255.255.0.0).
DHCP is disabled by default.
Monitoring system
The monitoring system is detects abnormal system operating conditions and
generates alarm outputs or messages, allowing users to take necessary actions
before system failure.
The monitoring system can detect a wide variety of internal system conditions
including temperature, voltage, fan operation, and power supply status. It can
generate several different alarm outputs, including audible signals to notify nearby
users or sending out alarm messages for remote notification. SNMP traps are also
available.
TruVision NVR 40 User Manual
17
Advertisement
Table of Contents
