DeWalt D28065-XE Instruction Manual page 7

WARNING: The grinding wheel or accessory may loosen during coast-down of
the tool when shut off if rubber ring is missing or damaged. If grinding wheel or
accessory loosens, it may dismount from the machine and may cause serious
personal injury.
• Always use proper guard with grinding wheel. A guard protects operator from
broken wheel fragments and wheel contact.
• Accessories must be rated for at least the speed recom mended on the tool
warning label. Wheels and other accessories running over rated speed can fly
apart and cause injury. Accessory ratings must be above listed minimum wheel
speed as shown on tool nameplate.
• Hold tool by insulated gripping surfaces when performing an operation
where the cutting tool may contact hidden wiring or its own cord. Contact
with a "live" wire will make exposed metal parts of the tool "live" and shock the
operator.
• Do not use Type 11 (flaring cup) wheels on this tool. Using inappropriate
accessories can result in injury.
• ALWAYS WEAR EYE PROTECTION WHEN USING THIS TOOL.
• Use of accessories not specified in this manual is not recommended and may
be hazardous. Use of power boosters that would cause the tool to be driven at
speeds greater than its rated speed constitutes misuse.
• Do not use circular saw blades or any other toothed blades with this tool.
Serious injury may result.
• When starting the tool with a new or replacement wheel, or a new or
replacement wire brush installed, hold the tool in a well protected area and
let it run for one minute. If the wheel has an undetected crack or flaw, it should
burst in less than one minute. If the wire brush has loose wires, they will be
detected. Never start the tool with a person in line with the wheel. This includes
the operator.
• Avoid bouncing the wheel or giving it rough treatment. If this occurs, stop the
tool and inspect the wheel for cracks or flaws.
• Direct sparks away from operator, bystanders or flammable materials. Sparks
may be produced while cutting and/or grinding. Sparks may cause burns or start
fires.
• Always use side handle. Tighten the handle securely. The side handle should
always be used to maintain control of the tool at all times.
FIG. 1
C
D
F
5
B
A
E
E
H
G