List Of Messages - Canon ZR 900 Instruction Manual

Additional Iniorrnation
Playback
During playback there is video noise.
- Video heads are dirty. Clean the video heads
(CD
2).
Playback does not start.
- Load a cassette
(CD
27).
- Set the camcorder to
1, . . . , . · · • • •
=PLA=·
Y=·l 2 §1=--"' 1
(CD
33).
- Tape reached the end ("
~
END" appears on the screen). Rewind the tape
(CD
27).
No sound from the built-in speaker.
- Open the LCD panel.
- Speaker volume is turned off. Adjust the volume with the [SPEAKER VOLUME] setting
(CD
34).
Image will not appear on the TV screen.
- Check again that the camcorder is properly connected to the TV
(CD
49).
Tape is running, but image will not appear on the TV screen.
- TVNIDEO selector on the TV is not set to VIDEO. Set the selector to VIDEO
(CD
50).
- Video heads are dirty. Clean the video heads
(CD
2).
- You attempted to play back or dub a copyright protected tape
(CD
52). Stop playback/dubbing.
Editing
Cannot record with this camcorder video input from an external video device connected using a DV cable.
- Wrong signal standard. Refer also to the instruction manual of the connected device.
List of Messages
(in alphabetical order)
CHANGE THE BATIERY PACK
- Battery pack is exhausted. Replace or charge the battery pack
(CD
17).
fit"?!-)
CHECK THE CASSETIE [AUDIO MODE]
- You attempted to dub audio
(CD
53) on a tape recorded with an audio mode other than
[mm
12bit].
N4n-)
CHECK THE CASSETIE [BLANK]
- You attempted to dub audio
(CD
53) on a tape with a blank section.
'leWr-)
CHECK THE CASSETIE [INCORRECT TAPE SPECIFICATION]
- You attempted to dub audio
(CD
53) on a tape recorded in HD (high definition) standard.
"~WI-)
CHECK THE CASSETIE [REC MODE]
- You attempted to dub audio
(CD
53) on a tape recorded in a recording mode other than SP.
64