Operation - DeWalt D28065 Instruction Manual

4-1/2" and 5" Sanding Flap Discs
Type 27 guard
hubbed sanding
flap disc
non-hubbed sanding
threaded clamp nut
Type 27 guard
Quick-Change
backing flange
NOTE: The guard is pre-adjusted to the
diameter of the gear case hub at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting
flap disc
screw (M) with clamp lever in the closed
position.
lever in open position. Undetectable damage to the guard or the
mounting hub may result.
not use tool and take the tool and guard to a service center to repair
or replace the guard.

OPERATION

turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories. Before reconnecting the tool, depress and
release the trigger switch to ensure that the tool is off.
9
3. With the guard latch open, rotate the
guard (D) into the desired working
position. The guard body should be
positioned between the spindle and the
operator to provide maximum operator
protection.
4. Close the guard latch to secure the guard
on the gear case. You should not be able to rotate the guard by
hand when the latch is closed. Do not operate the grinder with
a loose guard or the clamp lever in open position.
5. To remove the guard, open the guard latch, rotate the guard so
that the arrows are aligned and pull up on the guard.
CAUTION: Do not tighten the adjusting screw with the clamp
CAUTION: If guard cannot be tightened by adjusting clamp, do
WARNING: To reduce the risk of serious personal injury,
D
M