Preparing The Projector - Sony VPL-FE40 Operating Instructions Manual

[Autoconfiguration done] appears after the
installation is completed.
To continue projecting the pictures, check
the [Start Air Shot v2 and connect to
Projector] check box and click [OK].
Projector Station for Air Shot Version 2
starts up automatically.
When you are not going to project the
pictures, click [OK].
After executing [AutoConfig.exe], start up
the application with [PjstnASv2.exe].
When you change the computer, execute
[AutoConfig.exe].

Preparing the Projector

Setting the projector
1
Connect the network cable to the
NETWORK connector of the
projector.
2
Turn on the projector.
3
Press the INPUT E or AIR SHOT key
on the remote commander.
The home display of the network
presentation appears.
Serial number
Model name
Nick name (only
when specified)
Operations
guide
Icon
Icons representing network status:
being not connected
being connected
4
Press the ENTER key.
The setting menu display appears.
Network
Internet Protocol(IP)
Manual Mode1 Simple Mode
IP Address Setting:
Manual Mode2
IP Address:
Manual Mode3
Subnet Mask:
Manual Mode4 Default Gateway:
Manual Mode5
System Setup
Exit
5
Select the mode to be set and press the
ENTER key.
The setting items menu (action menu) is
displayed.
Set referring to the "Setting each mode"
on page 9.
Note
To use the network function, set [Standby
Mode] in the menu for the setup of the
projector to [Standard].
Mode
IP address
Manual
192.168.11.21
255.255.255.0
192.168.11.253
7
Preparation