Message Lists - Sony Bravia HDMI VPL-AW15 Operating Instructions Manual

Warning messages
Message
Cause and Remedy
High temp.! Lamp otT in 1
~
Turn off the power.
min.
~
Check to ensure that nothing is blocking the ventilation holes.
((1Y page 13)
Frequency is out of range!
~
Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector.
Please check Input-A
~
Set "Input-A Signal Sel." in the Setup
d~:
menu to
Signal Sel. "Computer" when an RGB signal is input from a computer.
((1Y
page 47)
Please replace the Lampl ~ It is time to replace the lamp. Replace the lamp.
((1Y
page 55)
Filter.
~
Also, replace the air filter too. Restart cleaning the Ventilation
holes (intake). ((1Y page 55)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process.
((1Y
page 55)
EmIl
To clear this message, press any button either on the remote control
or the control panel of the projector once.
Please replace the filter.
~
It is time to replace the air filter. Replace the air filter.
((1Y
page
58)
Please replace the filter.
~
It is time to replace the air filter. Replace the air filter.
(Gr
page
Have you finished? Yes No 58)
~ If you replaced the air filter, select "Yes." If you did not replace
the air filter, select "No."
Projector temperature is
~
Check to ensure that the Ventilation holes on the unit are not
high. Cooling Setting
covered.
((1Y
page 13)
should be "High" if
~
When using the projector at high altitude, set the Cooling
projector is being used at
Setting to "High".
((1Y
page 46)
high altitude.
EmIl
When temperature inside the projector remains high, the Cooling
Setting is switched to "High" in 1 minute, then the fan speed
increases.
Caution messages
Message Cause and Remedy
xEJ
~
No signal is input in the selected input. Check connections.
((jY
page 17)
Not applicable!
~ Press the appropriate button.
~ The operation to be activated by the button is currently
prohibited.
54