Reassembly - Hitachi CL 10SA Technical Data And Service Manual

8-2. Reassembly

Reassembly can be accomplished by following the disassembly procedures in reverse. However, particular
attention should be given to the following items.
(1) Reassembly of the power supply unit section
Be sure to perform wiring connections as indicated in the wiring diagram below (Fig. 31).
When connecting the internal wires to the terminals of the Switch [6], check that the flat springs of each
terminal are not deformed (Fig. 29). After connection, lightly pull the internal wires to check that they are
securely connected.
Noise Suppressor [8] Black
Brush Block Ass'y [25]
Blue
1
2
Brush Block Ass'y
[25] Red
Stator [22]
White
Brush Block Ass'y [25] Red
(2)
(3)
Stranded wire Gray
Cord [10]
Blue
Stator [22] Yellow
Stranded wire Gray
3
B. C.
4
F. C.
Stator [22]
Black
Fig. 31 Wiring diagram
Stator [22] White
(4)
(1)
Brush Block Ass'y [25] Blue
Stranded wire Gray
Stator [22] Black
Cord [10] Brown
M1
B. C.
M3
Noise Suppressor [8]
Black
Noise Suppressor [8]
Black
F. C.
M2
--- 17 ---
Stator [22] Yellow
Cord [10] Blue
1
C1
2
C2
Cord [10]
Brown