Charging And Using The Batteries; Operating And Charging Times Of The Batteries - Siemens HiPath 500 Operating Instructions Manual

Putting the handset into service

Charging and using the batteries

To charge the batteries, insert the handset into the charging shell with the
keypad facing forwards.
The charging status is indicated by the charge status display. This flashes
during charging:

Operating and charging times of the batteries

The operating times are only achieved after several charging and discharg-
ing cycles.
Capacity (mAh)
700
("Sanyo Twicell 650": 650)
16
Attention:
Only use the relevant approved power supply units for operating
the charging shell (for order numbers see
=
Batteries empty
e
Batteries 33% charged
V
Batteries 66% charged
U
Batteries 100% charged
Note:
• Initial charging: Charge the batteries for at least 5 hours with-
out a break, regardless of the charging status icon. Without
replacing it in the charging shell, use the handset until the "bat-
tery low" beep is heard. This action aligns the charge status dis-
play with the operating times of the batteries.
• To attain full operating and charging times (
out replacing it in the charging shell, use the handset until the
"battery low" beep is heard.
• For future charging: you can place your handset in the charging
shell each time it is used. Charging is electronically controlled
which ensures that the batteries are charged optimally.
Stand-by mode
(hours)
approx. 150 (6 days) approx. 10
page 112).
page 16): With-
Talk time Charging
(hours) time
(hours)
approx. 5 to 6