Starter System; Transmission; Cdi Magneto - Yamaha CW50L Service Manual

l..olo,..l
2. Remove:
_/ •o,utc, housing ® _ ____ ___ _ •Spacer ®
\ _._" /_ 2" Remove: _/_ ° Bearing _
• Secondary sheave (_) _ - Washer (_
• Crankcase cover gasket _ • Starter motor
• Dowel pins
3. Attach:
• Sheave holder (_)
• Nut wrench (41 mm)
l_ sheave h°lder: t _--'--_ o._ TRANSMISSION
90890-01701
• Transmission case O
___'_L 1. Remove:
_o3 4. Loosen: __ = Gasket
• Clutch securing nut ___II tc_ _, • Dowel pins
Loosen the nut but do not remove it yet,
2 Attach _ _ _ \ 2 Remove
- Main shaft _)
• Plate washer
/_ _ _ washer (_)
NOTE: _ t;_' _
__ _ ;_ • Conicalspring
Compressthe secondary sheave using the clutch _ \_._ ....
spring holder (_. (_)
Clutch spring holder: ____, ____(_ _ ......
_o_ 90890-01337
3. Remove:
6. Remove: _ • Oil seal (_)
• Clutch securing nut • Secondary sheave axle _)
• Clutch assembly (_)
• Clutch spring (_)
• Spring seat (_
• Guide pin (_) 3_,o_
• Secondary sliding sheave (_) CDI MAGNETO
• Nut O (rotor)
STARTER SYSTEM . Plate washer
_(_/___---(_) 1. Remove:
• Starter clutch assembly _ (_ NOTE:
_0_/_. /_ Plate (_ (idle gear) Hold the rotor using the flywheel holder (_) t°
• loosen the nut.
• Idle gear (_)
_@0@ _ • Starter wheel gear (_) _ F,ywheel holder: I
32_ 90890-01235
4-8
4-7