Controlling Another Cd Player (Advanced Mega Control) - Sony CDP-CX355 Operating Instructions Manual

Playing CDs
Controlling Another CD Player
(Advanced Mega Control)
1
Press MEGA CONTROL on this player.
The MEGA CONTROL button and "2nd" in the
display light up. The display shows the current
disc number or disc memo of the second player.
I
Current disc number or the Disc Memo
To control the master player again
Press MEGA CONTROL. The MEGA CONTROL button goes
off and you can control the master player.
2
Select the desired play mode.
To program tracks, use the controls on the second
player.
4
COl
2nd DISC
1*0. .
< 1 .S C
·~4.~,
ALL DISCS
3
Press
t>
on this player to start playing.
While the MEGA CONTROL button is lit, you can
control the second player with the controls on this
player.
To control the second player directly using the supplied
remote
Set CD 1(2(3 on the remote to CD 3 which is the same
position as the COMMAND MODE selector on the rear panel
of the second player.
This unit can control a second CD player (see
"Connecting Another CD Player" on page 6).
Even when a second CD player is connected, the
controls on both of the units will function. When you
press the play button on either unit, the operating
player stops and the resting player starts.
Make sure "2nd DETECTED" appears in this player's
display after turning on both players.
Note that depending on the player, you may not be
able to operate all the functions of the second CD
player.
I
MEGA CONTROL
c>
II
Play
mode buttons
(CONTINUE/SHUFFLE/
PROGRAM/REPEAT) KI<J AMS
l>I>{]
MENU/NO JOG
The controls indicated in the illustration below are effective
while the MEGA CONTROL button is lit.
0 0 0
0 0 0
0 0 0
000
000
000
0 0 0
0 0 0
0 0 0
I
[ >
I
0 0
8 8
818
8 0
COMMAND
MODE
selector