Electrolux Electric cooktops Installation Instructions And User Manual

Warranty
FOR SALES IN AUSTRALIA AND NEW ZEALAND
This document sets out the terms and conditions of
product warranties for Electrolux branded appliances. It is
an important document. Please keep it with your proof of
purchase documents in a safe place for future reference
should you require service for your Electrolux appliance.
General Terms and conditions.
1. In this warranty
(a) 'Electrolux' means Electrolux Home Products Pty Ltd ABN
51 004 762 341 in respect of Appliances purchased in
Australia and Electrolux (NZ) Limited in respect of Appliances
purchased in New Zealand;
(b) 'Appliance' means any Electrolux product purchased by you
accompanied by this document;
(c) 'Warranty Period' means
(i) where you use the Appliance for personal, domestic or
household purposes in Australia the period of "24" months
and in New Zealand the period of "24" months;
(ii) where you use the Appliance for commercial purposes, in
Australia the period of "3" months and in New Zealand the
period of "3" months, (if the period stated is 0 months you
are not covered by this product warranty)
following the date of original purchase of the Appliance;
(d) 'you' means the purchaser of the Appliance not having purchased
the appliance for re-sale, and 'your' has a corresponding meaning.
2. This warranty only applies to Appliances purchased and used
in Australia or New Zealand and is in addition to ( and does not
exclude, restrict, or modify in any way) any non-excludable
statutory warranties in Australia or New Zealand.
3. Electrolux warrants that, when dispatched from an Electrolux
warehouse, the Appliance is free from defects in materials and
workmanship for the Warranty Period.
4. During the Warranty Period Electrolux or its Authorised Service
Centre will, at no extra charge if your appliance is readily
accessible without special equipment, and subject to these terms
and conditions, repair or replace any parts which it considers to
be defective. You agree that any replaced Appliances or parts
become the property of Electrolux. This warranty does not apply
to light globes, batteries, filters or similar perishable parts.
5. Parts and Appliances not supplied by Electrolux are not covered
by this warranty.
6. Where you are within an Electrolux service area, this warranty
covers the cost of transport of the Appliance to and from
Authorised Service Centres of Electrolux and travelling cost for
representatives of the Authorised Service Centre to and from
your home or business. If you are outside an Electrolux service
area, you will bear these costs. For information about whether
you are within an Electrolux service area, please phone 13 13 49
in Australia or 0800 10 66 10 in New Zealand.
7. Proof of purchase is required before you can make a claim
under this warranty.
8. You may not make a claim under this warranty unless the defect
claimed is due to faulty or defective parts or workmanship.
Electrolux is not liable in the following situations (which are not
exhaustive):
(a) The Appliance is damaged by:
Before calling a Service Technician please check carefully the operation instructions,
service booklet and the warranty terms and conditions.
FOR SERVICE SERVICE AUSTRALIA
OR TO FIND THE ADDRESS OF
YOUR NEAREST STATE SERVICE
CENTRE IN AUSTRALIA
Please call 13 13 49
ELECTROLUX HOME PRODUCTS
For the cost of a local call (Australia only)
www.electrolux.com.au
FOR SERVICE
SERVICE NEW ZEALAND
OR TO FIND THE ADDRESS OF
YOUR NEAREST STATE SERVICE
CENTRE IN New Zealand
FREE CALL 0800 10 66 10
ELECTROLUX HOME PRODUCTS
l(New Zealand only)
www.electrolux.com.nz
(i) accident
(ii) misuse or abuse, including failure to properly maintain or
service
(iii)normal wear and tear
(iv)power surges, electrical storm damage or incorrect power
supply
(v)incomplete or improper installation
(vi)incorrect, improper or inappropriate operation
(vii)insect or vermin infestation.
(b) The Appliance is modified without authority from Electrolux in
writing.
(c) The Appliance's serial number or warranty seal has been
removed or defaced.
(d) The Appliance was serviced or repaired by anyone other than
Electrolux or its Authorised Service Centres.
9. This warranty, the contract to which it related and the relationship
between you and Electrolux are governed by the law applicable
in the Australian State where the Appliance was purchased
or the law applicable in New Zealand if the Appliance was
purchased in New Zealand. Where the Appliance was purchased
in New Zealand for business purposes the Consumer Guarantee
Act does not apply.
Limitation of Liability
10. To the extent permitted by law:
(a) Electrolux excludes all warranties other than as contained in
this document;
(b) Electrolux shall not be liable for any loss or damage whether
direct or indirect or consequential arising from your purchase,
use or non-use of the Appliance.
11. Provisions of the Trade Practices Act and State consumer
legislation in Australia, and the Consumer Guarantees Act, the
Sales of Goods Act and the Fair Trading Act in New Zealand, imply
warranties or conditions, or impose obligations, upon Electrolux
which cannot be excluded, restricted or modified. To the extent
permitted by law, the liability of Electrolux (if any) arising out of or
in relation to the Appliance or any services supplied by Electrolux
shall be limited (where it is fair and reasonable to do so):
(a) in the case of Appliances, at its option, to the replacement or
repair of the Appliances or the supply of equivalent products
or the payment of the cost of replacing the Appliances or
having the Appliances repaired or of acquiring equivalent
Appliances. Upon being replaced, parts and Appliances
become the property of Electrolux; or
(b) in the case of services, at its option, to the supply of the
services again or the payment of the cost of having the
services re-supplied;
and in the case of Appliances or services supplied in New
Zealand, loss or damage whether direct or indirect or
consequential that it reasonably foreseeable.
Privacy
You acknowledge that in the event that you make a warranty claim
it will be necessary for Electrolux and its Authorised Service Centres
to exchange information in relation to you to enable Electrolux to
meet its obligations under this warranty.
Important Notice
FOR SPARE PARTS
OR TO FIND THE ADDRESS OF
YOUR NEAREST STATE SPARE
PARTS CENTRE IN AUSTRALIA
Please call 13 13 50
For the cost of a local call (Australia only)
FOR SPARE PARTS
OR TO FIND THE ADDRESS OF
YOUR NEAREST STATE SPARE
PARTS CENTRE IN New Zealand
FREE CALL 0800 10 66 20
(New Zealand only)
P/No.305 5010 01 2010-02
1
INSTALLATION INSTRUCTIONS AND USER GUIDE
FOR ELECTRIC COOKTOPS
SQUARE CUTOUT
INSTALLATION INSTRUCTIONS
1. THE BENCH CUTOUT
2.
105
3.
4.
Fig. 1A
?
RUBBER SEAL (METAL ONLY)
?
?
HOB
?
5.
Fig. 1B
BURNER BOX
6.
?
BENCHTOP ?
CLAMP
SCREW
?
7.
Fig. 1C
ELECTRICAL CONNECTION
?
?
Loading prescribed on the cooktop data plate. The data plate
can be found on the underside of the cooktop.
Electrical connection is 220-240 volts AC 50Hz.
?
?
?
Fig. 2A
?
Supply cabe installation
?
?
?
?
2
should be made as per diagram (Refer Fig 1A).
ADJACENT WALLS (for Square & Rectangular cooktops)
must be of suitable material to withstand temperatures of
for 150mm high, i.e ceramic tiles.
A RUBBER SEAL has been provided for square metal
cooktops only. This is to be applied around the edge
of the hob (Fig.1B). Note: The rubber seal has had
talc powder applied to its surface which should be
wiped off with a damp cloth after the unit has been
installed.
PULL DOWN CLAMPS (Square cooktops) are
supplied. When the appliances is in position attach the
clamps to the underside of the benchtop and lightly
tighten (Fig. 1B).
Fit the pull-dwon clamps supplied to ensure that the
Cooktop cannot move after installation.
Use the 4 clamps and 4 screws supplied in the parts bag.
To assemble, attach the 4 clamps to each corner of the
Burner box via the screws provided (Fig.1C).
Position the cooktop so it is centred, then swing the
Clamps under the benchtop and tighten.
THE RECTANGULAR BENCH CUTOUT
should be made per diagram (Refer to Fig 2A.)
RETAINING BRACKETS (Refer to Fig 2B)
Rectangular cooktops are supplied attached to the sides
of the unit. These must be removed to insert the into the bench.
When the unit is in place, using the screws provided,
fix brackets with flange against underside of the bench
through several alternative holes provided in the sides of
the burner box.
Protrusions of brackets below the unit should be bent
under the unit for safety.
MODEL IDENTIFICATION STICKER For model
identification after installation, an additional data plate
sticker has been provided. This sticker is to be attached
to adjacent cabinetry.
The cooktop must be installed by a qualified electrician.
Ensure that the wiring installation complies with the cooktop
The cooktop must be installed in compliance with
wiring regulations AS/NZS 3000.
Local regulations, municipal building codes and other statutory
Regulations.
The cooktop must be properly earthed.
Warning: The cooktop must be installed by an
authorized person. Considerable danger to the user
or damage to the cooktop may result from
unauthorized installation. A visit from customer
service because of an error in installation may not
be free of charge even during the warranty period.
The electric hobs are supplied without cable. Use a cable:
2
H05 VV-F 3x2.5mm T90 ,or higher
Open the terminal box cover by using screwdriver inserted into the
Two rectangular holes. (Refer to terminal block cover)
Connect the wires according to circuit diagram (refer to the base of the hob).
The cable connections must be made in a accordance with regulations
And the terminal screws tightened securely.
Fix the cable in place with the cable clamp. Close the cover.
Means for diconnection must be incorporated in the fixed wiring in accordance
with local wiring rules.
The hob is to be connected to the mains using a device that allows the appliance
to be disconnected from the mains at all poles with a contact opening width of at
least 3mm.