Description Of Schematic Diagram - Sharp 13VT-K100 Service Manual

DESCRIPTION OF SECTION SCHEMATIC DIAGRAM
NOTE:
H
1. The unit of resistance "ohm" is omitted
(K:1000 ohms, M:1 Meg ohm).
2. All resistors are 1/8 watt, unless otherwise noted.
3. All capacitors are 50V, unless otherwise noted.
4. All capacitors are µF, unless otherwise noted. (P: µµF)
5. (G) indicates ±2% tolerance may be used.
VOLTAGE MEASUREMENT CONDITIONS:
G
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
2. All voltages measured with 1000µV B&W or Color
signal.
F
E
WAVEFORMS
D
C
B
A
1 2 3
13VT-K100/150
13VT-CK10
WAVEFORM MEASUREMENT CONDI-
TIONS:
1. Photographs taken on a standard gated color bar
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2. indicates waveform check points (See chart,
waveforms are measured from point indicated to
chassis ground.)
AND SHADED ( ) COMPONENTS
å
= SAFETY RELATED PARTS.
ç MARK= X-RAY RELATED PARTS.
å
DRGANNES MARQUES ET HACHRES (
PIECES RELATIVES A LA SECURITE.
MARQUE ç : PIECS RELATIVE AUX RAYONS X.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
4 5
71
13VT-K100/150
13VT-CK10
SCHEMATIC DIAGRAM : CRT, FRONT AV Unit
H
G
F
):
E
D
C
B
A
6 7 1 8 2 9 3 10 4 11 5
72
12 6