Model No. TH-55LFV50W Contents Operating Instructions FULL HD LCD Display • Important Safety Notice......2 • Safety Precautions ........3 • Accessories ...........6 • Parts and Functions ......8 • Connections ........10 • Technical Specifications ......11 For more detailed instructions, refer to the Operating Instructions on the CD-ROM.
If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic dealer. Do not cut off the mains plug.
If water is spills onto the Display or foreign objects get inside it, a short-circuit may occur which could result in fire or electric shock. If any foreign objects get inside the Display, please consult your local Panasonic dealer. Transport only in upright position! •...
Page 4
If water or foreign objects get inside the Display, if the Display is dropped, or if the cabinet becomes damages, disconnect the power supply plug immediately. • A short circuit may occur, which could cause fire. Contact your local Panasonic dealer for any repairs that need to be made.
Safety Precautions CAUTION When using the LCD Display Do not bring your hands, face or objects close to the ventilation holes of the Display. • Heated air comes out from the ventilation holes at the top of Display will be hot. Do not bring your hands or face, or objects which cannot withstand heat, close to this port, otherwise burns or deformation could result.
Accessories Accessories Supplied Check that you have the Accessories and items shown Operation instruction book CD-ROM (Operation instruction) Wire clampers Connector cable of remote AC Power Cord DVI cable control NOTE: • The remote control is not supplied.
VESA Mounting To mount this Display to a wall, you will have to obtain a standard wall-mounting kit (commercially available). 1. Lay a protective sheet on a table, which Protective Sheet was wrapped around this Display when it was packaged, beneath the screen surface so as not to scratch the screen face.
Parts and Functions Control Panel Remote control sensor Power status Indicator MUTE INPUT MENU POWER button MENU button Use this button to turn this Display on or put this Display Press to activate the OSD menu when OSD menu is off. to standby.
Page 9
Input/Output Terminals AC IN PC IN Connect the supplied power cord to the wall outlet. Input the PC source. MAIN POWER SWITCH AUDIO IN 1 Press to switch the main power on/off. Input the PC audio source (3.5 mm stereo phone jack). IR TRANSMITTER IN / OUT COMPONENT/VIDEO IN (BNC) Reserved for the wired connection of the IR control.
Connections AC Cord Connection Cable Securing 1. Plug the AC cord into this Display. There are three clampers supplied to secure cables at three positions. 1. Attach the clamper. 2. Plug the AC cord firmly until it clicks into position. Make sure he AC cord is locked on both the left and right sides.