Table of Contents
Advertisement
Local Echo Setting
■ Local Echo Setting
[Command] setup echo ECHO
[Parameter] ECHO: off, on
[Process]
Sets the local echo setting.
<Example> Setting the local echo to OFF
setup echo off <CR>
setup save complete echo<CR>
■ Current Local Echo Setting
[Command] setup echo
[Process]
Displays the current local echo setting.
■ Help of the Local Echo Setting
[Command] setup echo - -help
[Process]
Displays the help of the Local Echo
Setting command.
Reboot Request
■ Reboot Request
[Command] reboot
[Process]
Reboots the XCI-SX1.
Factory Default Settings
■ Factory Default Setting
[Command] setup factory
[Process]
Sets all the camera setting and Setup
values to the factory default setting
(except for the CDS gain and pedestal
level).
Note
This command works same as the "Default (All)" on
the HOME screen of the GUI application (page 14).
Resetting the Camera Settings
■ Resetting the Camera Stettings
[Command] setup default
[Process]
Sets all the camera settings other than
CDS gain and pedestal level to the
factory setting.
Note
This command works same as the "Default
(Camera)" on the HOME screen of the GUI
application (page 14).
External Control Commands
Saving the Camera Settings
■ Saving the Camera Settings
[Command] save
[Process]
Saves the camera settings (except for
the CDS gain and pedestal level).
Notes
• The camera settings aren't saved until the Save
command is received.
• This command works same as the "SAVE" of the
GUI application and the Web application (only for
the camera settings).
Loading the Camera Settings
■ Loading the Camera Settings
[Command] load
[Process]
Loads the camera settings.
Note
After loading, the camera's basic settings are
reconfigured (except for the CDS gain and pedestal
level).
Ethernet Mode Setting
■ Ethernet Setting
[Command] setup ether MODE
[Parameter] MODE: auto, 10half, 10full, 100half,
100full
[Process]
Sets the ethernet mode.
<Example> Setting the ethernet mode to 100 Base
Half
setup ether 100half<CR>
setup save complete ether<CR>
warning: the network will be
■ Current Ethernet Setting
[Command] setup ether
[Process]
Displays the current Ethernet mode.
■ Help of the Ethernet Setting
[Command] setup ether - -help
[Process]
Displays the help of the Ethernet
Setting command.
Notes
• Reboot the XCI-SX1 after changing the ethernet
setting.
• Reboot the XCI-SX1 after changing the ethernet
setting. Set this to the same setting as the
connected network.
restarted...<CR>
you may have to re-login if
you are linked via
telnet...<CR>
29
Advertisement
Table of Contents
