Change Toner - Toshiba DP 80F Instruction Manual

8

Change toner

As soon as the alarm lamp
message in the display, you should be prepared to replace the developer assembly. The „TONER LOW"
message indicates that only enough toner is left for a limited number of printouts (depending on the ratio of
black printed). In the event that you neglect to replace the developer assembly in good time, the „TONER
EMPTY" message is displayed, indicating that no more copies can be printed. All incoming faxes are saved in
the memory as long as this message is displayed.
1. Open the fax machine by
pressing the release button.
2. Remove the developer
assembly by pulling it out of
the fax machine with the green
grip.
(see page 5) lights up on your fax machine in combination with the „TONER LOW"
3. Remove the new developer
assembly from the packaging.
4. Then proceed as detailed on
page 7.
Caution:
In case you come into contact
with toner:
• If any toner dust comes into
contact with a textile fabric,
remove only by tapping the
fabric; if necessary, brush out
or use a vacuum cleaner. Never
rub.
• Wash hands in cold water and
clean thoroughly with soap.
• Wash eyes with plenty of
water.
• If you have inhaled toner, breath
deeply in the open air.
• If toner gets in your mouth,
wash it out with plenty of
water.
• In an emergency, call a doctor.
Consumables are taken
back and recycled by your
TOSHIBA dealer.