Panasonic CF-H1 Series Reference Manual page 70

Troubleshooting (Advanced)
Connecting Peripherals
A peripheral device does not work.
USB floppy disk drive does not work
as a boot drive.
You do not know the address map for
IRQ, I/O port address, etc.
When you use the Cradle, connect the AC adaptor to the DC-IN jack on the
Cradle.
Install the driver.
Contact the manufacturer of the device.
When operation resumes from standby or hibernation, devices such as a
mouse may not function properly. In this case, restart the computer or reinitial-
ize the device.
When is displayed in the Device Manager, remove and insert the device. If
the problem persists, restart the computer.
The computer may not recognize the connection/removal of some devices, or
may not operate normally with some devices.
Operate the following steps.
Click [start] - [Control Panel] - [Performance and Maintenance] -
A
[System] - [Hardware] - [Device Manager].
Select the device and remove the check mark for [Allow the computer
B
to turn off this device to save power.] in [Power Management]. (This
item may be unavailable for some types of devices.)
You can use only the Panasonic CF-VFDU03U USB floppy disk drive (optional).
Set [Legacy USB support] to [Enabled] in the [Advanced] menu of the Setup
Utility ( page 56).
Set [Boot Option #1] in [Boot] menu of the Setup Utility to [USB FDD Disk].
( page 57).
Turn off the computer and connect the USB floppy disk drive, and then restart
the computer.
To check the current address map, click [start] - [Control Panel] - [Performance
and Maintenance] - [System] - [Hardware] - [Device Manager] - [View] -
[Resources by type].
70