Related Manuals for DeWalt D28715-XE
Summary of Contents for DeWalt D28715-XE
- Page 1 INSTRUCTION MANUAL D28715-XE HEAVY-DUTY 355 mm (14") CHOP SAW WITH QUICK-CHANGE CLAMP...
-
Page 3: Definitions: Safety Guidelines
(sound pressure CALL US AT: 1800 444 224 (Aust) or 0800 339 258 (NZ). uncertainty) dB(A) Technical Data (sound power) dB(A) D28715-XE (sound power uncertainty) dB(A) Voltage Power Input 2,200 Vibration total values (triax vector sum) determined according to EN 61029-1 and... - Page 4 An estimation of the level of exposure to vibration should also take into account • USE PROPER EXTENSION CORD. Make sure your extension cord is in good the times when the tool is switched off or when it is running but not actually doing condition.
-
Page 5: Electrical Safety
Extension Cords • NEVER STAND ON TOOL Serious injury could occur if the tool is tipped or if the cutting tool is unintentionally contacted. CAUTION: Use only extension cords that are approved by the country’s Electrical • CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that Authority. -
Page 6: Components (Fig. 1)
INTENDED USE Your D28715-XE chop saw is designed for the cutting of variously shaped steel WARNING: Use of this tool can generate and/or disburse dust, which may cause materials. -
Page 7: Cutting Capacity
The D28715-XE chop saw is a professional power tool. DO NOT let children come For your convenience and safety, the following warnings are on your Heavy-Duty into contact with the tool. Supervision is required when inexperienced operators use 355 mm (14") Chop Saw: this tool. -
Page 8: Assembly And Adjustments
To Carry (Fig. 1) Spark Deflector Adjustment (Fig. 1) Fold down unit to position where you can carry the saw. Push in lock pin (A) to lock To best deflect sparks away from surrounding persons and materials, loosen the arm down. screw (B), adjust the spark deflector (C) and then retighten screw. -
Page 9: Operation
FOR A MORE ACCURATE SQUARE CUT FIG. 6 1. Unlock the fence. 2. Push the arm down until the wheel extends into the base. 3. Place a square against the wheel and adjust the fence against the square. 4. Lock the fence into position. FIG. -
Page 10: Cradle Mounting
Cradle Mounting NOTE: A keyed blade clamp system which includes a blade bolt and blade bolt washer, (Fig. 7, O, P) is available at extra cost from your local dealer or authorized 1. Cut two boards approximately 508 x 50.8 x 101.6 mm (20" long x 2" high x service center. - Page 11 ACCESSORIES FIG. 10 WARNING: Since accessories, other than those offered by D WALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only D WALT recommended accessories should be used with this product.
- Page 12 Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.co.nz (AUG12) Part No. N218493 D28715-XE Copyright © 2007, 2008, 2012 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...