D-Link DSM-600 User Manual page 10

Section  - Installation
D. While facing the back of the DSM-600, insert the right side of the hard drive
into the case. Once in place, snap down the left side.
E. Use the mounting screw to secure the hard drive to the DSM-600.Replace
the cover and screw the two screws on the back panel of the DSM-600.
F. Connect an Ethernet cable to the Ethernet jack located on the back of the
DSM-600 for initial setup.
Note: It is required that an Ethernet cable is used during initial setup.
D-Link DSM-600 User Manual 10